Construction
This is a picture of my chassis plate being cut out with a CNC Plasma Cutter the part file was turned into a DXF file to cut on the CNC plasma cutter. After this that holes will be drilled out for mounting the parts on the chassis plate
Figure 1: Chassis Plate
This is a picture of the suspension and chassis parts mounted to the chassis the three blue parts were 3-D printed at Central Washington University and then they were drilled out to be mounted to the chassis.
Figure 2: Suspension and Chassis
in this picture the student has a full assembly of the chassis and suspension portion of the car after this picture was taken the students started assembling the steering and drivetrain portion of the car.
Figure 3: Full Assembly of chassis and suspension
In this picture the student is tapping threads in the part that is going to be mounted up onto the end of the A-arms that are supporting the rear driveshaft. the student had this part printed at the MEC and drilled and tapped the part after the part was printed.
Figure 4; Tapping a part
In this photo the student was tapping threads in the side of the A-arms so that the student could munt up the shocks to the side of the a-arms. this was done after the part got 3-D printed at the MEC at the school after the part was printed the student had to drill out the support material in the a-Arms and after this the student could tap the threads.
